do not scale from this print .035 ref .038 ref 2.368 ref ((90 pos/30) x .7875) + .005 .725 ref .120 ref "a" "a" 1 3 item no. part number quantity material 1 qsh-30-01-d-03-a 1.0000 vectra e130i, color: black 2 c-126-21-f 160.00 phos bronze, 510 spring temper 3 t-1g2-01-f 3.0000 phos bronze, 510 half hard temper 4 tray-qxx008-pr-01-ap-t-a 1.0000 anti-static black hips .571 (29 eq spaces @ .0197) 2.413 ((90 pos / 30 x .7875) + .050) .78 ref .150 ref .626 ref .006 ref .285 ref .245 ref .036 ref 01 02 dp bank .128 - .001 + .003 .038 ref .007 .070 ref .2950 ref section "a"-"a" scale 2 : 1 2 .006 .011 (typ) .028 (9 plcs) .105 .068 (typ) 2.368 .0895 (typ) .017 (typ) .100 (typ) (2 plcs per bank) .185 (typ) (2 plcs per bank) .040 .0197 (typ) .1107 .551 .236 .571 (2 plcs) .250 (typ) .1925 (typ) .153 (2 plcs) .217 foot print c1 c any rev made to this print must have an updated mkt print sheet of unless otherwise specified, dimensions are in inches. tolerances are: decimals angles .xx: .01[.3] 2 .xxx: .005[.13] .xxxx: .0020[.051] .5mm dbl hs/dp socket assembly by: ASP-122953-01 dwg. no. description: proprietary note this document contains information confidential and proprietary to samtec, inc. and shall not be reproduced or transferred to other documents or disclosed to others or used for any purpose other than that which it was obtained without the expressed written consent of samtec, inc. do not scale drawing rrc 1/13/06 1 1 sheet scale: 3:1 c:\enterprisevault\dwg\misc\mktg\ASP-122953-01-mkt.slddrw ground plane & contact plating: contact area: .000003 gold over .000050 nickel 520 park east blvd, new albany, in 47150 phone: 812-944-6733 fax: 812-948-5047 e-mail: info@samtec.com code: 55322 notes: 1. bank 1 is differential pair, bank 2 & 3 are single ended. 2. represents a critical dimension. 3. minimum ground plane & contact retention: 8 oz. 4. maximum burr allowance: .0015. 5. maximum height variance of .002 applies to signal or grounds independent of the ground or signal pins respectively. 6. ground plane press height must be .003 less than the max height or .002 greater than the minimum height of signal pin. 7. parts to be packaged in trays. revision g
|
